Remember this lovely little stack from my new favorite craft store? I sewed like a maniac and now its a quilt for my sweet sister in law’s wedding gift.
The quilt measures about 67” by 80”, perfect size for a 2 person couch quilt, or draped over the end of a bed. Here’s my measurements if you want to make your own.
For the inner border you’ll need:
1- 4.5” square
2- 2.5” by 4.5” strips
2- 2.5” by 8.5” strips
Sew short sides on first, then top and bottom pieces. If you are not using 1/4” foot (like I wasn’t) you will get some hangover in your strips that you’ll have to trim. The seam allowance on a regular foot is more like 5/16” or 6/16” in my case, so slightly larger than 1/4”. So if your strips seem way too long, especially in the outer border, that is probably why.
For the outer border you’ll need:
2- 2.5” by 8.5” strips.
2- 2.5” by 12.5” strips.
Your finished block should measure 12.5”. See that little bit of hangover on the top and bottom of my block? That’s because I didn’t use my 1/4” foot, so my finished block was more like 12”. Which isn’t a big deal unless your using a (real) pattern or you’re concerned about the final size.
Now square up your blocks. I made 30 blocks, I used about 4 yards of fabric for my blocks. The sashing strips were 1.5” cut, so 1” finished. The white border strips were 2” cut. When your using thin stashing strips like this its important to pin and line up your blocks as you sew your rows together. If not you can really tell when your blocks don’t line up perfectly. And unpicking stitches is not that much fun….as I’m sure we all know very well.